RSS RSS

Outdoor/NEMA
Access Point Enclosures


These enclosures are designed to permit convenient and secure mounting of the access point in difficult or outdoor environments. Some of these enclosures include a universal mounting plate for access points from many vendors, “keyed alike” locks, and egress points for bulkhead mounted antennas and conduit. The enclosures are designed to the UL50 standard for enclosure integrity. With proper egress point seals, the enclosures are NEMA 4 compliant for water and dust resistance.

Model 1021-00
Oberon Model 1021-00 wireless access point enclosure
  • Ideal for stadium installations. Oberon’s NEMA enclosures are an excellent match for Cisco 3502p wireless access point and MIMO Patch Antenna Array stadium antenna
  • Designed for mounting wireless access points with non-detachable antennas indoors or outdoors where secure weather proof installation is required
  • Door has a neoprene perimeter gasket
  • Construction: ABS plactic, grey, paint-able; NEMA-4 capable when openings are properly sealed; Virtually transparent to RF signal
  • UL listed and tested to UL508-4X requirements
  • Typical temperature rise is less than 10°C with powered access point (to avoid excessive heat build-up in the enclosure, avoid direct exposure to sunlight)
  • Size: 12" x 10" x 6"  deep
  • Weight: 4 lbs
Enclosure PDFs:

Spec Sheet | Installation Instructions | Customer Prints

back to top
 

Model 1025-00
Oberon Model 1025-00 wireless access point enclosure
  • Designed for mounting wireless access points with non-detachable antennas indoors or outdoors where secure weather proof installation is required
  • Large enough for Cisco 1250 802.11n wireless access point with 6 internal dipole antennas
  • Use Cisco AIR-AP-BRACKET-2 when mounting Cisco 1250, 1260, 3500, and 3600 series wireless access points
  • (2) ¾ trade size cable feed-through openings in the bottom
  • Fully hinged locking door, weather-proof lock. Door has a neoprene perimeter gasket
  • Construction: 30% fiberglass reinforced polyester, grey, paint-able; NEMA-4 capable when openings are properly sealed; virtually transparent to RF signal
  • UL listed and tested to UL508-4X requirements
  • Typical temperature rise is less than 10°C with powered access point (to avoid excessive heat build-up in the enclosure, avoid direct exposure to sunlight)
  • Size: 13" x 15" x 6.5"  deep
  • Weight: 10½lbs
Enclosure PDFs:

Spec Sheet | Installation Instructions | Customer Prints

back to top
 

Model 1026-00
Oberon Model 1026-00 wireless access point enclosure
  • Ideal for stadium installations. Oberon’s NEMA enclosures are an excellent match for Cisco 3502p wireless access point and MIMO Patch Antenna Array stadium antenna
  • Designed for mounting wireless access points with non-detachable antennas indoors or outdoors where secure weather proof installation is required
  • Fully hinged door wit lock clasp. Door has a neoprene perimeter gasket
  • Construction: ABS plactic, grey, paint-able; NEMA-4 capable when openings are properly sealed; Virtually transparent to RF signal
  • UL listed and tested to UL508-4X requirements
  • Typical temperature rise is less than 10°C with powered access point (to avoid excessive heat build-up in the enclosure, avoid direct exposure to sunlight)
  • Size: 12" x 10" x 6"  deep
  • Weight: 6 lbs
Enclosure PDFs:

Spec Sheet | Installation Instructions | Customer Prints

back to top

 


Home  |  Products  |  Partners  |  FAQs & Resources  |  News  |  About Us  |  Support

© 1999-2012 Oberon, Inc.  |  Privacy/Legal  |  Webmaster  |  1-877-867-2312  | 
Valid XHTML 1.0 Transitional